Feature:

Specification:

Item Type: Bathtub Heater
Material: Stainless Steel
Color: As shown in the picture
Product Size: Approx. 30x13.5x5.5cm / 11.8x5.3x2.2in
1# Pipe Connector Size:
Thickness: Approx.4mm / 0.16in
Height: Approx.4.4cm / 1.7in
No Thread Outside Diameter: Approx.5.7cm / 2.2in
2# Pipe Connector Size:
Thickness: Approx.3mm / 0.12in
Height: Approx.4.4cm / 1.7in
No Thread Outside Diameter: Approx.5.7cm / 2.2in
Weight: Approx.1550g/54.7oz
Model: H30-R1
Product Power: 3KW
Working Voltage: AC220-240V
Waterproof Rating: IPX5
Current: 13.6A
Applicable Bathtub Water Capacity: 1280L
Purpose: Constant temperature heating
Heater Type: Water heater
Applicable Places: Massage bathtub, bathtub SPA

Installation Method:
1. The bathtub water heater should be connected to the tubing circulation system, and can also be connected to the inlet and outlet of the bathtub pump to ensure that the direction of water conforms to the instructions on the bathtub water heater.
1. The heater must be installed horizontally.
2. The heater can be installed with the inlet or outlet of the bathtub pump. (Note: Cannot be fixed by binding)
3. PVC pipe: cut a specific length of polyethylene from the pump outlet and connect to the nozzle. (Note: The size of the pipe joint should be the same as that of the bathtub pipe)
4. Pipe joints: clean the PVC pipe joints, and then use glue to connect the PVC pipe and joints together. (Note: installation distance between heater and pump)
5. Heater installation: Separate the connecting nut and connect the PVC pipe to the heater (Note: O-). Make sure the connection is tight enough. (Note: The connecting nut is made of plastic material, too much force will cause damage).
6. Connect the knob to the thermostat heater at the threaded diameter of the fitting, then apply glue to the inside of the fitting connector without thread, and then insert the pipe to be connected (in addition, the outer wall of the pipe is also coated with glue, so that it is more firm).
7. After the bathtub heater is installed, it must be checked:
●If the pipe or connection is ing: Pour water into the bathtub and run the pump for 30 minutes to ensure that the circulating water system does not .
●If the heater does not start, try to find the problem in the most common faults and possible solutions provided.

Package List:

1 x Bathtub Heater

1 x English Manual

2 x 1# Pipe Connector

2 x 2# Pipe Connector

Note: